The Open.Theremin kit is an Arduino shield to build a real, playable theremin music instrument. The theremin is played with two antennas (included in this bundle), one to control the pitch and one for volume. The electronic shield is built with two heterodyne oscillators, same principle as the original Theremin. The Arduino micro-controller is there for linearisation and filtering and also generates the instruments sound that is then played through a high quality digital analog audio converter on the board. The characteristics of the sound can be changed by a hex wave table. The Open.Theremin V3 is based on the popular Arduino UNO development board and can be reprogrammed easily.
The more than three years of experience in building good quality and affordable digital theremins lead to this new and improved design version 3. It features a new fully automatic one button calibration of the antennas. A new mute function as well as a knob to adjust the sensitivity (Register) and wave form (Timbre).
- Pitch and volume antenna with excellent linearity and digital tuning
- Arduino compatible shield for easy programming
- Full digital auto-tuning (one button press)
- 12bit digital to analog converter generates audio out signal
- Waveform can be reprogrammed freely (stored in a look-up table)
- USB powered, no extra power supply required
- Can be powered by battery
- Low profile SMD design for simple shipment
- Pads to screw or solder on antennas or antenna cable
- One button interface
- Distance of hand to antenna is converted to a digital value that can be used for other applications than theremins
- Mute function
- 8 preprogrammed audio wave forms can be selected
- Pads to connect grounding directly to board
- Completely open source hardware and software (OSHWA Certificate CH00001)
The Kit includes the assembled and tested electronic board as well as mechanical and electronic parts to set up the open.theremin.
Included in the kit:
- Open.Theremin V3 shield (tested)
- Pin headers
- 2x Antenna plugs for board mounting
- 4 x potentiometers
- 1 Button
- Screws, nuts and washers for mounting antennas and front panel
- 2x 5 mm square LED-lights
- Acrylic pad to attach camera stand (1/4″ UNC)
- Volume antenna
- Pitch antenna (two parts with connector)
The antennas are made from golden anodized 6mm aluminum tubing and fit well with the theremin design and connectors.
The Arduino.UNO and tripod are NOT included in the kit.
Comes with printed build instructions.
FREE SHIPPING worldwide.
For more infos see Instruction Manual.